Hi everyone,
first post, great that such a large self-help community exists and my empathy to everyone that suffers here.
I have taken FIN for 3.5 years now and want to quit this ASAP as I am super scared of getting permanent damage from it and very shocked the more I read about it. I do have some typical, minor to medium side-effects. I have taken 0.5mg for the past 8 months and 0.25mg since two weeks.
After everything I have read so far, especially the theory about “Silenced Androgen Receptors” http://www.protocol-online.org/forums/uploads/monthly_08_2010/msg-19273-027408800%201282061244.ipb - I believe it is best to slowly get off the pill for the body to recalibrate itself rather than quitting cold turkey. The question is, over which time-span and which dosages? Continuous doses each day? Or On/off? I have read recommendation to follow the recommendation for SRRIs anti depressants to reduce the active ingredient by 10% per week from the base, meaning a 10 week wean-off phase. But is that careful enough? Read on another forum that an andrologist weans off over a course of two years with high-tech lab equipment… Given the difficult flat response finasterid inhibition curve it seems most important to slowly reduce from 0.2mg to 0mg as that is where the ingredient shows noticeable reduction in the blood serum. Which brings me to the main problem:
How do I “mechanically” do the microdosing of the pills? It becomes physically impossible to just cut the pill in smaller parts after 0.25mg and precisely create 0.2, 0.18, 0.16mg … pills. The 1mg pill itself (using the brand FINARISTO) has a weight of 124mg, meaning 1mg of Finasterid inside that pill is extremely little given the whole mass and making me question whether microdosing is even physically possible or more like a roulette because even with perfectly precision-weighted pill parts you never know how much of the active ingredient ended up in that little part.
- To me there are two ways to microdose: Splitting/Crush and weighing the pill or dissolving it in alcohol for more exact measurements and than counting drops in the end. What is the best approach?
- Do we know whether the 1mg Finasteride is evenly distributed in each part of the pill?
- Do we know whether cutting a pill into pieces will cause the active ingredient to oxidate/react and be less after several days?
- Is it possible to crush and grind the pill and then weigh it down to 0.02mg parts and less or is no pharmaceutical lab that is somewhat accessible for us private people able to do this? Assuming this would even work because the active ingredient is evenly distributed in the pill?
- Is it possible to dissolve the whole thing in alcohol for easier dosing?
- If yes which alcohol
- how to store the solution, how long is it good to use?
- Will it be evenly distributed in the liquid just by shaking it before using a syringe to take the exact amounts out?
- Can the alcohol be sucked from a spoon danger-free or is too strong (e.g. Ethanol, Isopropanol…) and will harm the mouth and internals? Okay to squirt the amount from a syringe into a glass of water and drink that?
- Again, in which schema would you dose over which time-span to minimize risks for the body?
- Is it a bad idea to do weight training while dosing off?
If none of this works I will just have to split into really smart parts using sand paper and doing a purely visual measurement of the size. I hope you guys can help me, shitscared to get/have PFS and right now just looking for an answer how to move on so I can get my mind off this topic and stop continuously examining myself and going crazy.
Thank you a lot!